Dedicated line questions

Guys, thanks for all the responses, i would be lying if i didn't admit that much of what u guys are talking about is going way way over my head. this is my thing. the breaker board or whatever u call it for my house just happens to be in my listening room, can i just not buy a 20 amp fuse, put it in one of the empty slots, run power chord from it to my hospital grade hubbles, and voila, dedicated power line?????

Korn: Don´t skip the separate grounding!! Not the ideal setup as has been described. Definitely you´ll get improvement over where you are now.

Whta exactly do u mean by seperate grounding?

The use of copper grounding rods only for your system mentioned in the above notes. I haven´t go that far to three separate and so forth but use two it´s worth the effort. What I actually did is I´m feeding my system out of the 220 volts electric range breaker (I use a gas one now) so it was a freebie (nice isn´t it)taking two 110 volts one for the amp and another for front end using dedicated grounding rods. Regards

I have recently renovated my house and added a dedicated room. I ran one 20A circuit to two outlets, and then installed two other outlets on another 15A circuit that also runs to other outlets in the house. I included the second circuit expecting to plug in a lamp, record vacuum, etc. After setting up, I have discovered that my amp sounds best when plugged into the dedicated circuit all by itself! This forces my front end onto the common circuit. My recommendation therefore is to run TWO dedicated circuits to your system, one for the amp(s) and one for the front end.