celestion a2 tweeter blown or not


I have a Celestion A2 floor standing speakers, both tweeters are now silent after I hooked them up to a Karaoke system and started to sing ;^(. I took them out of the enclosure and looked inside particularly at the diaphragm, they both look intact, clean and undamaged. What can be wrong with my speakers ?

Any idea for how to fix it ? Looking for original parts might be a dead-end since these models have been discontinued for years.

Both the Midrange and Woofer still sound very good, seems not being affected. I don't know if anything in the cross-over might cause the tweeter to not being able to function.
simbatran
Got them replaced by F-series tweeters as suggested by Celestion/KEF of America. Sound acceptably OK. Able to retain the housing, so outside will look unchanged. But inside, behind the housing, the tweeter is one piece, you cannot separate the diaphragm from the magnets, and does not look as impressive as the old one since the new one is pretty small and of different material. The faraday ring from the old tweeters were partially reused and clipped on top of the new tweeters.

Just some info for those who have to fix Celestion A series like mine. Hope this helps.

The cost of two tweeters is approx $60 plus $40 labor for the pair.
This week I was lucky to find 2 pairs of Celestion 5 for a price of $30 for both, locally through Craigslist, both have the tweeters in very good shape. I used one pair of tweeters to replace the F-series currently installed in my A2. The other pair, I use it in another room and also keep it as a backup just in case.

Thanks to info from this forum, in deed the tweeters are identical, except that the A2 tweeter has a Faraday ring that the C5 does not. Other than that, they are the same.

Just remove the diaphragm from the C5 and re-use the magnet from the A2. The speakers now sound sensational like before, which is far better than the cheap F-series tweeter that I temporarily installed earlier on.

This is what I did to remove the diaphgram. First I removed the 3 inner cricle screws to allow me to detach (lift off) the magnet, but still keep the housing on the diaphgam, then I used a hairdryver and turn it on to high, then blow it on the housing side surrounding the diaphragm, but not on the coil, just do it for about 10 seconds, not longer just to be sure not to overheat it, the heat caused the glue to melt and allow me to easily peel off the diaphgram from the housing.

After that, it is just a simple task to mount it back on the A2 and reused the magnet of the A2 that has the Faraday ring.

Before starting, be very careful to mark which side the positive is. Also the magnet is extremely strong, it can suck up the screws and metal pieces, so keep those far away. Also try to blow off the dirt during the work to keep the diaphram clean.

Voila, a good pair of A2 speakers again.
I'd like to correct an earlier post that said the faraday was reused, actually, it was only a piece of wood that allows the F-series tweeter driver part which is of different size, very small and not thick enough to be clamped on by the old metal bar.