Can the sound of SS amp deteriorate over time??


Would like to know if the quality of the sound of a "high- end" solid state amp can deteriorate over a period of 10-15 years. That is, the the bass sounds less tight and controlled, the sound is less clean and clear and imaging is less focused and precise. I realize that a tube pre-amp or power amp are subject to this deterioration in sound depending on the quality and condition of the tubes.... Need some technical advice
sunnyjim
Porziob: Thanks for clearing that up for me. I, my annnually calibrated test equipment ( HP spectrum analyzer, tracking generator, AF & RF signal generators, Tek scopes, etc... )and the experiences of the mass majority of my customers must all be mistaken. I guess that i'll have to start denying the differences that the customers experience and what i can measure, based on your above testimony.

Qdrone: It is my personal belief that leaving equipment on causes less stress than power cycling it up and down on a regular basis. That is, so long as their is more than adequate ventilation for such and "dust bunnies" that can accumulate both on and in the gear are addressed on a somewhat regular basis. Not only that, but i think that most gear sounds better too. Obviously, this is just my personal opinion, so take it for what it is worth. Sean
>

Sean...In the field of ballistic missile guidance systems (lots of very complex and precise solid state electronics) we have rather extensive experience with continuous operation and with on/off operation. (The Air Force operates continuously while the Navy operates on/off). Navy systems are commonly deployed without problems for six to ten years, whereas Air Force systems last a much shorter time (which I can't tell). Believe me, the Navy has also looked very closely at possible accuracy benefits of continuous operation, and it is not significant. However, it is important that the Navy systems opearate in a "Dormant" mode when "off", where heaters distributed throughout the system maintain temperatures very close to those that exist during operation.
Yes it can, for a varity of reasons. The main resevoir caps(the large cans) in most high end amps are charged thru a very low series resistance. The current surge upon turn on present a "shock" to the cap, and over time causes excessive DC leakage. This can easily be measured, however after 10 yrs of, say daily cycling, it becomes prudent to replace them in order to avoid the possibility of the cap shorting. Many quality amp provide a means to adjust output transistor idle bias and DC offset. This needs to be periodicly checked and/or adjusted. Semiconductor chactoristics change over time and temperature cycling. I can provide assistance in most cases, if you are interested.
Eldartford: In effect, the systems that you discussed are tempurature and environment controlled without being exposed to transient power variations. As such, i would expect most any reasonably built product to last a long time and work properly when called upon to do so.

Outside of those conditions and getting back to the real world, where thermal swings and power transients exist on a regular basis, i'll stick by what my past experiences have shown me. Sean
>
Sean I agree with your assessment. The heat factor of constantly going hot to cold (when equipment is turned off) to cold to hot(when equipment is turned on) is stressfull to the components in your equipment. Dormant stage on stereo equipment is alot better than powering up equipment from an off state. Yes good ventilation is essential and will prolong the life of your components.