calling all audiophiles


Is it ok to connect an amplier straight to the wall? I thought it sound better without the monster HTS 2000 power conditioner, I just dont know if it is wise to do this. Any feedback or recommendation would be appreciated.

My amp is a parasound 2205.
wallst202
tim: please give me the name of your plasterer; i'll pay his airfare. :o) BTW, the amps i'm talkin' about have user-switchable 110/220v inputs. see, e.g., : http://www.boulderamp.com/bldramp.2060.html

-kelly
Correct me if I am wrong but people seem to confuse spikes, noise and thunder. Thunder or excessive spikes are easy to control as they are usually adressed by devices in parallel with the line so they short when a high voltage hits MOV and gas tubes are usualy used. I haven't heard any comments on isolation transformers these can decouple your gear from the line which is a huge benefit (any comments?) as far as the 220V/110 comment goes this is usually a diode acting as a Voltage divider not really a benefit in my opinion.
My brother is using an isolation transformer on all of his line level components to great effect. Can't really do this with a good sized amp though, as most "reasonably priced" isolation transformers are relatively low current.

As to MOV's absorbing or shunting spikes, that is partially true. You need to keep in mind that MOV's definitely DO "burn out" or lose efficiency over time. The higher the voltage surge or spike and the more often that these devices have to deal with that type of situation, the more likely they are to fail. Just because it is plugged into a "surge protector" does NOT mean that it is "fully" protected. Sean
>
Has anyone tried the Transparent Powerlink / Powerblock Ultra units. They claim to have some outlets on them that do not limit power.

Aknorth