Building your own high end turntable stand?

I have used this and it works very well, but don't use now because current room is smaller.
http://www.audiophilia.com/hardware/diyttstand.htm

My TT sits on a wall mounted platform. I used 2 - 10" x 10" x 1 .25" - 1/4" steel L brackets recessed into a 3/4" plywood shelf with beveled edges faced down and painted flat black. The L brackets are pocketed at the bend into slots in a wall mounted 1" cleat, allowing for shimming of the trailing legs to level the shelf under the weight of my Systemdek IIX. The shelf is directly over my rack, with the reversed beveled platform it appears to float. I recently moved a couple of components on my rack and moved it out on a diagonal to rearrange the interconnects just as wife wife was passing, with surprise in her voice she said " Has your turntable always been mounted like that?" Only for the past 15 years.

Hi everyone, I saw the following item at a "designer" store recently and thought that it might be a very good support for my Rega RP3, but I would like to get some feedback before purchasing.

Do you think a big concrete brick would be a good support for my turntable, or an I better off with a wall mount instead (or a wood-based solution)?

Here's an image of the item, it is very heavy although not 100% filled with concrete (otherwise it would have been unmovable).

http://farm4.staticflickr.com/3753/10058933755_9ac5b59d54_b.jpg

Odedia

Go to Amazon.com and get a Peerless Adjustable Component wall Shelf for AV EQ for 38.00 bucks will support up too 100lb you can then mount some Isolation cones upside down and then either make your own shelf top or use a 2" to 4" thick cutting board from E bay for around a hundred bucks. O r you could make one like I did out of 3/4" Birch plywood top and bottom with a 3/4" particle board center and picture framed the outside edge with 3/4" solid Maple I glued the three pieces together with liquid nails instead of wood glue with the though that it would help Isolate each piece of wood from each other better that Elmer's glue. The three piece shelf ways about 35lb and my B&O 4002 weight about 26lb, I am going to add a 2" thick solid Maple cutting Board (30.00 bucks) with four (12.00 bucks) super balls in between the two boards for isolation another 30lb for a total of 91 lb.'s
Approx. 140.00 bucks

@Markfina, thanks for the wall shelf info. This looks like a very flexible solution. I made my own wall shelf mounted TT rack out of some steel from old speaker stands, but might try this one as an alternative since it is such a great price. Have you had any problems with the arms flexing any under weight? How flexible is the mounting location as you match the wall rack up to the stud locations?