2. cables
  3. 167666-2717

AQ Water XLR or Yukon XLR - DAC to Preamp- sound comparisons

Hi all,

I have an opportunity to upgrade from my Yukon XLR that I just purchased to the AQ Water XLR interconnects that are connected to my Oppo 105D dac to my Marantz preamp. I find the Yukons are good but I think the Waters will provide that extra smoothness and detail in the bass, clarity and even more openess. The Yukons are a nice interconnect as well and I found at first there was a brightness and midrange harshness  that was not so pleasing to my ears and the bass was a bit more laid back but having them in my system for over a week they seem to be breaking in and the sound is not as harsh and it seems to have settled in and the sound is clear and refined. I also have an AQ Monsoon power cable hooked up to my preamp as well and perhaps that is helping as well with the presentation of the sound I am describing. I am using AQ Water XLRs from my preamp to power amp as well.

I want to know does anyone have any experience with either one of these interconnects hooked up from dac to preamp? What are your experiences in having either one of these cables hooked up from your dac to preamp? Has anyone tried the Yukons in their system and then went with the Waters or vice versa? Since my Marantz preamp is a warm sounding preamp would the Waters cause the sound to be overly warm cause I have them hooked up to my preamp and power amp and perhaps the Yukons provide that balance with the blend of highs and midrange forwardness to my Waters I have from my preamp to power amp? On a side note if it matters but I will be upgrading to the Blizzard power cable for my preamp very soon. 

I would like to keep this to Yukons and Waters as I have no intentions right now to move up the line for now or try other brands. Thanks in advance and appreciate your thoughts.

2007audioman
2007audioman
2007audioman OP
80 posts
 
Thanks gdnrbob. I understand those WELs are very revealing interconnects for sure. Right now my budget is only for the Waters. I found Mackenzies were nice but slightly a little warmer then I thought but still had a nice bass to it and warm midrange. Highs were a bit laid back compared to the Yukons. The Mackenzie XLRs I have are hooked up to my power amps to do Atmos duty and that should be enough as its only ambience sound I figured. I did try them out though just to see what sound they could give on my dac to preamp. 

 If I am interpreting your post right you are suggesting to get the best interconnect and perhaps that will happen sooner than later if I can get a good price on a pair. I have asked my dealer to go ahead and order the Water XLRs shortly after writing this message but I figured it cant get any worse and can only add to the sound over the Yukons. Whether its incremental will still be an improvement that I should be able to discern from the price point and I can live with it. Having both Waters from dac to preamp and preamp to my power amp will provide more consistency in sound.

Thanks a lot for your response. I really appreciate it.

2007audioman
2007audioman OP
80 posts
 
Hi all,

It would still be nice to hear from a forum member who has this setup. If you have this setup AQ Waters from your dac to preamp and AQ Waters from your preamp to power amp or receiver would be great to hear from you and let me know the sound you get from your setup? Do you plan on going up further in the AQ line and why? Maybe you already have gone up further and what line did you move up too and the improvements you are hearing by going up in the Element series line? Thanks all.

2007audioman
mkash3
57 posts
 
Have you checked out the Red River XLRs? They're cheaper but they're one of the very few Audioquest products which use gold connectors. If AQ used gold XLR/RCA connectors on their top of the line products, I'd be all over them.

I replaced the factory-terminated silver spades on my Rocket 44 cables with AQ's 5000 series gold spades and couldn't believe the difference it made.
2007audioman OP
80 posts
 
Hi mkash3. Thanks for your response. No I never checked out the Red River XLRs. My dealer suggested to not go below the Mackenzie XLR interconnects when I converted to XLR from RCA so I went with his advice. I use an AQ Gibraltor speaker cable for my main front left and right speakers that have the gold connectors on them. They sound good too although my surround and surround backs have the AQ Suregrip 300 silver connectors and they sound good as well. I may eventually go all silver and will be upgrading my speaker cables at some point in time. Thanks again for your response.

2007audioman
jayctoy's avatar
jayctoy
4,040 posts
 
Water is on onothe league is way better than Yukon , TMRaudio usually have them used .
More to discover